24
Mar.2005
5. Return the modulation lever toward yourself; if a value of “0” is
reached,a click will sound, the display will indicate “OK”, and you will
proceed to the next test.
(The “OK” indication will not appear unless you perform the tests in the
order of Bender Left, Bender Right, and Modulation.)
8.A/D Test 2 (Control Knob)
fig.lcd-t15-c1.eps
Perform this test in the order of C1, C2.
1. Turn the knob all the way toward the left; if “0” is reached, a click will
sound.
2. Turn the knob all the way toward the right; if “127” is reached, a click will
sound
3. Turn the knob to the center; if “63/64” is reached, a click will sound and
the display will indicate “OK.”
If all knobs are “OK”, you will automatically proceed to the next test.
9.A/D Test 3 (Hold Pedal, Expression Pedal)
fig.lcd-t16-hold.eps
1. Connect a hold pedal to the rear panel HOLD jack, and an expression
pedal to the rear panel CONTROL jack.
2. Press the hold pedal; a click will sound when the display indicates “127.”
3. Release the hold pedal; a click will sound when the display indicates “0”,
and “OK” will appear.
4. Advance the expression pedal; a click will sound when the display
indicates “127.”
5. Return the expression pedal; a click will sound when the display indicates
“0”, and “OK” will appear.
6. If both HOLD and CTL are “OK”, you will automatically proceed to the
next test.
10.D BEAM ADJUSTMENT
fig.lcd-t17-beam.eps
D BEAM ADJUSTMENT
Here you will make D BEAM settings. Before you begin this test, verify that
there are no objects within 50 cm of the GW-7. (If any such objects are within
this range, the settings cannot be made correctly.)
Do not perform this test in direct sunlight.
1. Place your hand 5 cm above the D BEAM and press the [ENTER] button.
If the setting was made correctly, the display will indicate “OK.”
2. Place your hand 45 cm above the D BEAM and press the [ENTER] button.
If the setting was made correctly, the display will indicate OK and you
will automatically proceed to the next test.
11.D BEAM Test
fig.lcd-t18-beamtst.eps
This checks the operation of the D BEAM.
1. Move your hand in a range from 5 to 45 cm above the D BEAM, and
verify that the value increases and decreases.
2. Place your hand 5 cm above the D BEAM and verify that a value of “127”
is displayed.
3. Place your hand 45 cm above the D BEAM and verify that a value of “0” is
displayed.
4. Place your hand 30 cm above the D BEAM and verify that a value greater
than “1” is displayed.
5. Press [ENTER] to proceed to the next test.
12.SWITCH & LED Test
fig.lcd-t19-sw.eps
This checks switches and LED.
When you enter this test, all LED will light.
1. When you press a switch that has an LED, the LED will go dark.
The number of switches you have not yet pressed is shown in the upper
right of the screen.
The lower line of the LCD shows the name of the switch you pressed.
If more than one LED corresponds to one switch (button), press that
switch the corresponding number of times.
<FILTER>, <ENV>, <BACKING>, <EFFECT>LED = [SELECT] switch
(button)
2. When all switches have been pressed, you will automatically proceed to
the next test.
If you press more than one switch at once, the bottom line of the LCD will
indicate “WARNING!!”
If this occurs, use the [SHIFT] button + SELECT [ < ], SELECT [ > ]
buttons to re-select the SWITCH & LED Test item, and perform the test
again.
To Next Page
Loading...
