Roland GX-640/GX-500/GX-400/GX-300 User Manual

Setup Guide
GX-640/GX-500/GX-400/GX-300
BE SURE TO READ THIS FIRST
This document describes the included items and accessories, program installation and
setup, and other important matters. Be sure to read this manual before use.
Thank you very much for purchasing this product.
 To ensure correct and safe usage with a full understanding of this product's performance, please besure to read
through this manual completely and store it in a safe location.
 Unauthorized copying or transferral, in whole or in part, of this manual is prohibited.
 The contents of this operation manual and the specifications of this product are subject to change without
notice.
 The operation manual and the product have been prepared and tested as much as possible. If youfind any
misprint or error, please inform us.
 Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which mayoccur through
use of this product, regardless of any failure to perform on the part of this product.
 Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which mayoccur with respect
to any article made using this product.

Roland GX-640/GX-500/GX-400/GX-300 Specifications

General

Model	GX-640/GX-500/GX-400/GX-300
Type	Cutting Plotter
Cutting Force	20 to 600 gf
Acceptable Material Width (GX-640)	24 inches (610 mm)
Acceptable Material Width (GX-500)	20 inches (500 mm)
Acceptable Material Width (GX-400)	16 inches (400 mm)
Acceptable Material Width (GX-300)	12 inches (300 mm)
Cutting Width	Varies by model
Maximum Media Thickness	1 mm
Cutting Speed	600 mm/s
Software Resolution	0.025 mm
Mechanical Resolution	0.025 mm
Interface	USB
Power Requirements	100-240 VAC, 50/60 Hz
Dimensions	Varies by model
Weight	Varies by model
Media Width	Varies by model