Need help?Do you have a question about the Roland CAMM-1 PNC-950 and is the answer not in the manual?
General| Type | Vinyl Cutter |
|---|---|
| Max Cutting Width | 590 mm |
| Interface | RS-232C |
| Dimensions | 900 mm |
| Power Requirements | 100-240 V, 50/60 Hz |
| Maximum Resolution | 0.025 mm |
| Blade Holder | Roland Cutter Blade Holder |
Indicates a point requiring care for serious injury or death.
Indicates a point requiring care for serious injury or death.
Indicates a point requiring care for minor injury.
Important information to prevent breakdown or ensure correct use.
Warns against disassembling or modifying the product.
Advises careful handling of the power cord to prevent damage.
Prohibits insertion of liquids, metal objects, or flammables into the machine.
Warns against unstable locations and advises area safety checks before operation.
Advises keeping body parts away from the carriage and platen during operation.
Explains the location and meaning of labels affixed to the product.
Stresses careful handling of the product due to its precision nature.
Advises against installing in environments with dust, humidity, or poor ventilation.
Warns against connecting to outlets with incorrect voltage specifications.
Recommends unplugging the unit when not in use for an extended time.
Identifies and describes the components visible from the front.
Identifies and describes the components visible from the rear.
Details the controls and indicators on the operation panel.
Details the physical placement and space requirements for the unit.
Explains how to connect the unit to a computer and power source.
Step-by-step instructions for inserting a blade into the blade holder.
Procedure for detaching the blade holder from the tool carriage.
Instructions for powering on the unit and initial carriage movement.
Guides on how to load flat or rolled sheets onto the machine.
Diagrams and explanations for correct sheet placement relative to grit rollers.
Configuring application software for output device and interface selection.
Procedures for pausing, resuming, or terminating a cutting job.
Rotates text or graphics 90° to utilize unused sheet material effectively.
Details the Centronics standard for parallel communication.
Details the RS-232C standard for serial communication.
To Next Page