Roland CAMM-1 PNC-950 - Downloading Cutting Data; Software Settings for Cutting; Pausing Cutting Operations

14
4-7 Downloading Cutting Data
The unit will begin cutting when it receives cutting data sent from the computer.
• Software Settings
When cutting with commercially available application software, select PNC-950 as the setting for the output device. (If
the PNC-950 cannot be selected, choose any model in the PNC-900, PNC-1100, or PNC-1000A).
Select either the parallel (Centronics) or serial (RS-232C) interface. Choose the one that the host computer and the PNC-
950 are connected by.
• Pausing Cutting Operations — PAUSE Key, PAUSE LED, and SETUP Key
If you want to stop the PNC-950 momentarily while it is performing cutting, follow the procedure described below.
Procedure
(1) Press the PAUSE key.
PAUSE
→
To Terminate Cutting
(2)-1 Halt transmission of cutting instructions from the
computer.
(2)-2 Hold down the SETUP key.
The PAUSE LED lights up and cutting is paused
(2)
To Resume Cutting
Press the PAUSE key.
↓
PAUSE
The PAUSE LED goes out and
cutting resumes
SETUP
* If you want to completely stop the operation of the PNC-950, turn off the power switch.
↓
The SETUP LED goes out, cutting instructions already sent from
the computer to the PNC-950 are deleted, the tool carriage moves
to the right, and cutting stops