Roland SC-545EX Print&Cut - User Manual

Thank you very much for purchasing the product.
• To ensure correct and safe usage with a full understanding of this product's performance, please be sure to read
through this manual completely and store it in a safe location.
• Unauthorized copying or transferral, in whole or in part, of this manual is prohibited.
• The contents of this operation manual and the specifications of this product are subject to change without notice.
• The operation manual and the product have been prepared and tested as much as possible. If you find any
misprint or error, please inform us.
• Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may occur through
use of this product, regardless of any failure to perform on the part of this product.
• Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may occur with
respect to any article made using this product.
User’s Manual

Roland SC-545EX Print&Cut Specifications

General

Brand	Roland
Model	SC-545EX Print&Cut
Category	Printer
Language	English

Summary

To Ensure Safe Use

General Warnings on Page 5

Lists critical safety warnings presented on this page.

Safety Warnings on Page 7

Safety Warnings on Page 8

Safety Precautions on Page 9

Chapter 1: Getting Started

1-3 Assembling and Installing

1-5 Switching On the Power for the First Time

Initial setup procedure including ink installation.

1-6 Installing the Blade

Procedure for safely installing and removing cutting blades.

Chapter 2: Basic Operation

2-3 Loading Media

Detailed instructions for loading various types of media.

2-4 Printing

Procedures for performing printing tasks.

2-5 Cutting

Procedures for performing cutting tasks.

2-6 Printing and Cutting

Performing printing and cutting operations sequentially.

2-7 Reloading and Aligning Media

Steps for realigning and cutting after printing using crop marks.

Chapter 3: Using the Print Heater

3-1 Switching the Print Heater On and Off

3-3 Printing and Cutting

Performing printing and cutting with the print heater active.

Chapter 4: A Wide Variety of Operations

4-1 Replacing the Ink Cartridges

Guide for changing ink cartridges.

4-3 Setting the Location Where Printing Starts

4-5 Making Corrections for Printing

Adjustments to improve print quality.

4-6 Making Corrections for Printing and Cutting

Aligning print and cut positions.

4-7 Stopping Printing or Cutting Operations

Chapter 5: Maintenance

5-1 Print Head Cleaning Procedures

Instructions for cleaning the print heads and troubleshooting persistent issues.

5-2 Cleaning Using the Cleaning Kit

Detailed procedure for cleaning with the provided kit.

5-3 Replacing the Wiper

5-5 Disposing of Discharged Ink

5-6 How to Replace the Blade

5-7 How to Replace the Separating Knife

5-8 When Moving the Unit

Chapter 7: What to Do If...

7-1 Troubleshooting Common Issues

Guide to resolving operational problems like machine not running or poor print quality.

7-2 Error Message Resolution

Guide to interpreting and resolving machine error messages.