11
Sep. 2013 HPD-20
Important Notes on Assembly
PLAYING PLATE
When attaching the playing plate (#5100034517) to the upper cushion
(#5100036155) and the lower cushion (#5100036156), give attention to the
following points.
1. Attach the playing plate to the upper cushion.
fig.kumitate1-e.eps
2. Place the lower cushion on top of the upper cushion.
fig.kumitate2-e.eps
3. Invert the playing plate while holding down the areas shown by red
circles in the figure.
fig.kumitate3.eps
4. Attach the playing plate (with cushion).
fig.kumitate4-e.eps
PAD HOOP
Tighten the screws in sequence from 1 to 10.
fig.kumitate5-e.eps
BOTTOM CASE
Tighten the screws in sequence from 1 to 11.
fig.kumitate6-e.eps
Refer to View 9 (p. 10).
: For positioning
protrusion
OK Not OK
Be careful not to allow mispositioning.
Note: For positioning pin
(8 locations)
1
2 10
3
7
84
9
5
6
Note: For positioning pin
(2 locations)
1
2
3
4
5
6
7
9 8
11
10
Note the differences in level between
top and bottom.
Ensure no displacement to either side.
Note difference in screws.
To Next Page
Loading...
