Roland HandSonic HPD-20 - Attaching to a Stand

MIDI Implementation
11
MIDI Visual Control Messages
 MIDI Visual Control ON
Transmitted when entering MIDI Visual Control mode.
Status Data byte Status
F0H 7EH, 00H, 0CH, 01H, F7H
10H, 00H, 00H, 01H, nnH,
10H, 01H, sum
Byte Explanation
F0H Exclusive Status
7EH ID Number (Roland)
00H Device ID (00H xed)
0CH Model ID#1
01H Model ID#2
10H 00H 00H Address
01H Data (MIDI Visual Control ON)
nnH Data (Clip Control Rx MIDI Ch.
(00H-0FH (ch.1-ch.16) ) Initial Value = 0FH (ch.16) )
10H Data (Eect Control Rx MIDI Ch. (OFF) )
01H Data (Note Message Enabled (ON) )
sum Check Sum
F7H EOX (End Of Exclusive)
* The unit will enter MIDI Visual Control mode if Control Mode (MENU --> SYS -->
MIDI --> VISUAL) is set to “MVC” and MIDI Visual Control (MENU --> SYS --> MIDI -->
VISUAL) is turned “ON.”
* MIDI Channel (MENU --> SYS --> MIDI --> VISUAL) setting is used as the Clip Control
Rx MIDI Ch.
* Only the Clip Control Rx MIDI Ch address (10H 00H 01H) and data are transmitted
when the MIDI Channel setting is made in MIDI Visual Control mode.
 MIDI Visual Control OFF
Transmitted when exiting MIDI Visual Control mode.
Status Data byte Status
F0H 7EH, 00H, 0CH, 01H, F7H
10H, 00H, 00H, 00H, 70H,
Byte Explanation
F0H Exclusive Status
7EH ID Number (Roland)
00H Device ID (00H xed)
00H Model ID#1
0CH Model ID#2
01H Command ID (DT1)
10H 00H 00H Address
00H Data (MIDI Visual Control OFF)
70H Check Sum
F7H EOX (End Of Exclusive)
* The unit will exit MIDI Visual Control mode if the MIDI Visual Control (MENU --> SYS
--> MIDI --> VISUAL) is turned “OFF” or if Control Mode (MENU --> SYS --> MIDI -->
VISUAL) is set to “V-LINK.”