Roland HandSonic HPD-20 - What is the HandSonic?; Look What You Can Do with the HandSonic

MIDI Implementation
5
 Channel Mode Messages
* Following Channel Voice Messages can be received in MIDI Channel (MENU --> SYS
--> MIDI --> MIDI).
All Sound O (Controller Number 120)
Status 2nd byte 3rd byte
BnH 78H 00H
n = MIDI channel number: 0H–FH (ch.1–ch.16)
* When this message is received, all currently-sounding notes on the corresponding
channel will be turned o immediately.
Reset All Controller (Controller Number 121)
Status 2nd byte 3rd byte
BnH 79H 00H
n = MIDI channel number: 0H–FH (ch.1–ch.16)
* When this message is received, the following controllers will be set to their reset
values.
Controller Reset value
Polyphonic key pressure 0
Foot Controller 0 (Open)
Hold 1 0 (O)
General Purpose Controller 4, 5 0 (O )
General Purpose Controller 6–8 Depends on Realtime Modify settings
Eect Controller 1, 2 Depends on Realtime Modify settings
Sound Controller 1–10 Depends on Realtime Modify settings
Pitch Bend Depends on Realtime Modify settings
All Note O (Controller Number 123)
Status 2nd byte 3rd byte
BnH 7BH 00H
n = MIDI channel number: 0H–FH (ch.1–ch.16)
* The same processing will be carried out as when All Sound O is received.
OMNI OFF (Controller Number 124)
Status 2nd byte 3rd byte
BnH 7CH 00H
n = MIDI channel number: 0H–FH (ch.1–ch.16)
* The same processing will be carried out as when All Sound O is received.
OMNI ON (Controller Number 125)
Status 2nd byte 3rd byte
BnH 7DH 00H
n = MIDI channel number: 0H–FH (ch.1–ch.16)
* The same processing will be carried out as when All Sound O is received.
MONO (Controller Number 126)
Status 2nd byte 3rd byte
BnH 7EH 00H
n = MIDI channel number: 0H–FH (ch.1–ch.16)
* The same processing will be carried out as when All Sound O is received.
POLY (Controller Number 127)
Status 2nd byte 3rd byte
BnH 7FH 00H
n = MIDI channel number: 0H–FH (ch.1–ch.16)
* The same processing will be carried out as when All Sound O is received.