6
The REPEAT A-B SETTING screen also plays an important role in track
editing, as we’ll see.
5 If you like, you can manually refine the A and B points to get them
more precisely where you want them, adjusting them either by bars
and beats, or by time.
You can clear either the punch-in or punch-out point—A or B,
respectively—by highlighting it onscreen and pressing 5 (CLEAR.)
6 Press 2 (AUTO) to turn on Auto-Punch.
7 Press EXIT to leave the screen.
8 Press the DIGITAL RECORDER REC button so it flashes, and
then make sure the track or pair of tracks you want to
punch is/are also flashing red.
9 Go to a spot in the song before the punch-in location so you have a
chance to get your bearings before recording begins.
10 Press the PLAY button to start playback.
When you get to the punch-in location, the REC light stops
flashing and the JUNO-Gi automatically punches in.
11 Play or sing what you want to fix.
When the song reaches the punch-out location, the JUNO-Gi
automatically punches out and REC starts flashing again.
12 Press STOP and listen to your punch. If it’s not good
enough, repeat Steps 8-11 to try again. You can attempt a
punch as many times as you need to.
13 When you’re done with punching, clear your punch point to turn
off Auto-Punching. To do this, press RECORDER VIEW to go to the
RECORDER screen, and then press the REPEAT A34B button once—
”Clear A-B” appears momentarily onscreen.
7 As soon as you’re done, press REC again to punch out.
8 Press STOP and go back to listen to your punch. If it’s
not good enough, repeat Steps 3-7 to try again. You can
attempt a punch as many times as you need to.
A connected foot switch—like a Roland DP-2, DP-10, or FS-5U—makes
manual punching much easier, since you can punch in and out in Steps 5 and
7 without using your hands. To set this up, connect your foot switch to the
JUNO-Gi’s PEDAL CONTROL jack, and set the System Control Pedal
Assign parameter to RECORDER REC, as described on page 81 in the
Owner’s Manual.
Automatically Punching in and Out
When you use the Auto-Punch feature,
you set your punch points ahead of time,
and then the JUNO-Gi automatically
switches in and out of recording for you
during the punch. You set it up using the
DIGITAL RECORDER area’s REPEAT A34B
button.
Here’s how to use Auto-Punch on a track
you’ve just recorded:
1 Start playback of the song before the area you want to punch.
2 When you get to the spot at which you want to punch in, press the
RECORDER REPEAT A34B button once. This sets the A, or punch-in,
point.
3 When you get to the spot at which you want to punch out, press
the RECORDER REPEAT A34B button once more. This sets the B, or
punch-out, point.
4 While holding down SHIFT, press the RECORDER REPEAT A34B
button to display the A-B SETTING screen.
To Next Page
Loading...
