Roland JV-80 - Page 13

2.
TURN
THE
POWER
ON
After
making
the
proper
connections,
turn on
tiie power
according
to the
procedure
given
below.
[1
]
Before you
turn on the
power,
check the
following
points:
•
Are
all
connections made
correctly?
•
Are the
volume controls
of the
aoiplifier and
other
equipment turned
down?
•
Is the
volume
control of the JV-80
turned
down?
[2]
Turn
on the
power
switch on the
rear
panel of the
JV-80.
The following
display appears.
The JV-80
has a
protection
circuit that
mutes the
output for a
few seconds
after the
power
is
turned on.
[Example of
the
display]
r'ERFORM
tPERFORM
NRME:
Pai-t
Ln^Mel
IQl
f 1
27 i 127 1
127
1127 8
127 i 127 1
127! l:^/
J^
Upon
power up, the
JV-80
recalls the last
selected
Performance
or Patch.
[3]
Turn on the
power
of the
connected
devices,
such as the
amplifier,
and adjust the
volume.
[4]
Adjust
the sound
volume
with the
master
volume
control of the JV-80.
VOLUME
'
Maximum
volume
i^
Adjust the
sound at the
TVA
level (P.36),
Resonance (P.46)
or
the
Part level
(P.59) if
the sound
is still
distorted even after
adjusting the
overall
level with
the master
volume slider.
Minimum
volume
[5]
When turning
off the
power,
first turn
off the
external
devices, then
turn off the
JV-80.
^
Be
careful not to set
the output
level too
high when
connecting the JV-80
directly to
an audio system.
The
speakers may be
damaged by
an
excessive volume
level.
13