Write
I
Write Mode
>
Write
The
settings which are executed
by operation step
[4] are explained
In
each section below.
Edited data can be stored in internal memoi7
or on a DATA card. When storing
the data in interna!
memory, niake sure the protect
function is disabled (OFF).
The LCDs displayed differ depending
on the mode which
was
last selected
before
|
WRITE] was
pressed.
^
When storing
data in internal memory, the write operation
cannot be executed if the protect function
(P.
166}
is set to ON. If you try to store data when
the protect function is on,
a
display
appears to tell you
that it's on, followed
by a second
display which
allows you to turn the
protect function off. Press
j
DEC
[
to
turn off the protect function.
^
When writing
to a DATA card, turn off the protect switch
on the DATA card after inserting
the card into
the DATA
card slot. Turn the protect switch
back on after completing the operation
in order to protect
the
data.
Performance Play/Performce
Edit Mode
-
Write
PERFORM
WRITE Performance Write
This operation stores the Performance
data currently in the temporary area.
PERFORM rrrop-i
TEMP 11 Press ENTER]
WRITE
ito HiiUKSyn Lead
::-
Name
of
the Performance
to be
stored
Number of
the Performance
to be
stored (I
=
Internal.
=
DATA card)
[Operation]
The destination
Performance number is
selected by using
[
INT/CARD
A/B
|
/ |
BANK]
/ ]
NUMBIr"
[INC
[
/
|DEC
|
or Parameter Slider 1
.
The name of the
selected Performance is displayed
within the parentheses.
155
To Next Page
Loading...
