I
Write Mode
I
Card
Card
This command transfers
the data between internal memory
and DATA card or PCM card.
When this
command is selected, a
display appears
allowing
you
to select the type of data transfer.
DflTfixPCN U.ard
I n t
-^
C ard Q C a i-
d
.'
I n t S I nt
^
->
C:
ar- d I P U
t'l
C: a r- d
[Operation]
select the desired
operation by using
|
"^
j
/ |
|
or Parameter Slider 1 (the
selected operation flashes),
then press!
ENTER
I-
NOTE
You can create
Performances on the
JV-80
by
combining Patches
from both internal memory and
DATA card.
When copying Performance data
created in this way from
internal memory to DATA
card or
vice versa, take care to
avoid possible problems, such as
described in the example
below.
(Example) In
this example, a
Performance numbered 101 has
been programmed, and in
it Part
1
has
been assigned to
Patch 112 and Patch Cll
has been assigned to
Part 2. When the
Performance is copied
from internal memory to
DATA card, it is stored as "COl"
in the
DATA card. In
this operation, the Patch
of Part 1 is stored as "Cl2"
and the Patch of Part 2
stays
the same as Cll
.
If this
copied Performance is
copied again, this
time from DATA card
back to internal
memory, the
Performance is stored as
"101,"
and Part 1
is stored as
"112"
to
internal
memory.
However. Part 2 is now
stored as "III."
Therefore, even though the
Performance
number is the same as
that of the
original data, the Patch
number set for Part 2 has been
changed.
Performance
101
Copying to
DATA card
Performance
001
Performance
101
2 has been
changed
1
2
112
Copying to
111
internal memory
. .
by
the Part
Execute the bulk dump
function (P.
164)
when
you want store the
internal data as it
is, without
being changed.
161
To Next Page
Loading...
