2.Troubleshooting
•
Check that
the
effects and LFO
are correctly
set
Check the
following:
O
The chorus value which
is
set for the
Performance/Patch
O
The analog
feel
value which Is set for the Patch
O
The switch/depth value of FXM which is set for the Tone of a
Patch
O
The pitch LFO depth
value
which is set for the
Tone
of a Patch
O
The depth
value
and
the controller position of the modulation/
aftertouch/expression control which is set for the Tone of a
Patch,
when the parameter is
set to
pitch LFO
#
It may
happen that the sounding pitch range is limited, or
that a
Tone doesn't deviate from a certain pitch range, or
that
the tuning sounds off, depending on the selected
vi/ave.
The controllers
do
not work
#
Check the
mode/assign settings of pedals
1/2
and CI,
which are set in the system common
parameters.
#
Check the transmission/receiving switch of the controller.
Check the following:
O
The
MIDI transmit/receive
settings
made
in the system common
parameters
O
The
receive volume/hold
1
settings
made for the Part of a
Performance
O
The
volume/hold
1
settings
made
for
the pedal of the Tone of a
Patch
#
Check the modulation/aftertouch/expression control
settings made for the Tone of a Patch. The effect is not
applied when the parameter
Is set to off or the depth is
set to 0.
O
The
receive
program
change value which is set for the Part of a
Performance
#
Check that the MIDI channel settings are correct:
O
The control channel value which is set in the system common
parameters
O.The Patch transmit/receive channel value which is set in the
system
common
parameters
O
The transmit
channel
value which is set for the transmit zone of
a Performance
O
The receive channel value which
is
set
for
the Part of a
Performance
#
The layer/zone key mode and the single key mode of a
Performance may have
different settings for the program
change
to
be transmitted and the MIDI channel.
#
When the Patch select
display is selected
in the
Performance
Play mode,
the Performance cannot be
changed.
#
Check that the Edit mode has not been selected:
O
Changing Performances or
receiving program changes is not
possible in
the
Performance Edit mode.
O
Changing Patches or receiving
program changes is not possible
in the Patch Edit mode.
O
Changing Rhythms or receiving
program changes
is not
possible in the Rhythm Edit mode.
O
From the Performance Edit mode, program change messages
cannot
be
transmitted even though the value of the transmit
program change of the transmit zone has been changed.
The effects
do
not work
#
Check that the effect switch is on:
The
sound color does not change
or program change messages are
not sent
#
Check that the switches which allow sending and
receiving
of program change messages are
not
set to
OFF:
O
The program change setting for IvliDI transmit/receive which is
set in the system common parameters
O
The
transmit program change value which
is set for the transmit
zone of a Performance
O
The chorus/reverb switch on the front panel
O
The chorus/reverb switch
setting which is made for the
Part
of
a Performance
#
Check that the setting of the
Performance and the effect
of a Patch have been made
correctly. The effect is not
applied when the
chorus/reverb level is set to 0.
•
Check that the
setting of the Patch and Rhythm Tone
have
been made
correctly. The effect is not
applied
when the
chorus/reverb send, which is set by the
effect
send parameter, is set to 0.
172
To Next Page
Loading...
