Roland JV-80 - Page 214

I
Index of Functions and
Operations
• Having the JV-80
and several
external MIDI Instruments
sound at different pitches
To
set the transposition of the
note number being transmitted from
the transmit zone
^
Press
]
TX TRANS
l
and select the TX. Transpose page
63
5.
Transmitting and receiving
sound program data
^
• Exchange sound
program data, such as that of
Patch, Performance
and Rhythm Set, with
an external
device.
To execute the
bulk damp function
-*
Press! WRITE land select Bulk
164
Edit
In this section, page
references are
given
for
changing the parameters of the Patch and
Performance Play modes
and the system common
parameters.
1. Setting the
pitch of the sound
(Performance Edit mode)
•
Change the
pitch for each
Part.
• Adjust the
relative pitch of
each Part.
To set the
coarse tune and fine tune for
the Part
-*
Press
I
PART
)
and
select the Coarse Tune and
Fine Tune pages
137
(Patch Edit mode)
•
Change the pitch
for each Tone.
To set the pitch shift coarse
and pitch shift fine
-*
Press
I
PlTCH~|
and select the PITCH page
102
2.
Set the
modulation
]
(Patch
Edit mode)
• Add modulation
and vibration to
the sound.
To
set LFOs 1 and
2
-*
Press
!
WAVE/LFO
|
and select
the LFOl and LF02 pages
98
• Add 1/f
modulation to the so
und.
To set the analog
feel function
-»
Press
[EFFECT
l
and select the ANALOG FEEL
page
89
• Change the
pitch for each t^ey
p
layed
To set the random
pitch
-*
Press FpITCH
l
and
select the PITCH page
102
3. Set
the stereo
position of the
sound
• (Performance
Edit mode)
Chang
e
the stereo
position for
each Part.
To set the
pan of the Part
-*
Press
[
PART
l
and select the Pan
page
136
(Patch
Edit mode)
•
Change the
stereo
position for each Tone.
To
set the pan offset
value of the
TVA
-*
Press
[
TVA
|
and select the
TVA
page
HI
•
Change the
stereo position
of the entire
Patch, without
changing
the relative
stereo
position
of the Tones.
To
set the Patch pan
-^
Press]
COMMONland
select the PATCH
COMIV^ON page
84
214