Roland JV-80 - Page 30

1.
PLAYING
PATCHES
What
is
the Patch
Play
mode?
In the
Patch
Play
mode, a
single Patch
is
called up to
the
temporary
area from
where it
can be
played. A
Patch
consists of
a
maximum
of four
Tones, and
the
parameters
of
each
Tone
are
controlled
by
Parameter
Sliders
1
—4
or the
iTONE
SWITCHI
buUons
(1
—4).
However,
since
the data
which is
called up
to the
temporary
area is
used when
a
Performance is
selected,
the
original
Patch in
the
internal
memory
or
DATA
card will be
retained.
The
data being
used in
the temporary
area can
be
stored as
a
new
Performance in
the
user
memory.
(See
Command
Section,
Write Mode)
Since
the
Patch Play
mode
allows
you
to
control each
Tone
of
the
Patch
and fully
utilize the
expressive
capabilities
of one
sound
program,
it
adds a
new
dirnension
to the
playing
of
lead
lines and
lets
you
create
sounds that
were
previously not
possible.
30