26
Other new functionality
A function has been added that automatically applies the channel names on the M-480 to the track names on the R-
1000 when an R-1000 48-track recorder/player is connected via REAC and the M-480 is used as a recording source.
This function does not work when the version of the R-1000's system program is earlier than 1.100.
1. Display the R-1000 CONTROL popup.
2. At PREFERENCE, select the Name sync check box.
When recording is performed on the R-1000, the channel names on the M-480 used as the recording source are
applied to the track names on the R-1000.
The following rules are used to assign the track names according to the settings for the recording-use INPUT
patchbay on the R-1000 (the input connector assigned to the recording track) and the M-480's patchbay settings.
Automatic application of M-480 channel names to R-1000 track names
Assignment to R-1000 recording track Applied track name
MAIN L, R, C Channel name
MAIN MONO MAIN M
AUX 1 – 16
Channel name
MTX 1 – 8
MONITOR L, R MON L, MON R
REC L, R REC L, REC R
CH1 to 48 direct out
Channel name
RTN1L to 6R direct out
OSCILLATOR 1, 2 OSC1, OSC2
REAC A IN 1 – 40
When the corresponding input port is patched to the input channel,
the channel name.
When not patched, A IN1 to A IN40
REAC B IN 1 – 40
When the corresponding input port is patched to the input channel,
the channel name.
When not patched, B IN1 to B IN40
CONSOLE IN 1 – 8
When the corresponding input port is patched to the input channel,
the channel name.
When not patched, C IN1 to C IN8
STEREO IN L, R
When the corresponding input port is patched to the input channel,
the channel name.
When not patched, ST INL to ST INR
CAS OUT MAIN L, R, C
channel nameCAS OUT AUX 1 – 16
CAS OUT MTX 1 – 8
CAS OUT SOLO L, R SOLO L, SOLO R
To Previous Page
Loading...
