2
Functionality added in version 1.5
✔ New functionality has been added to scene memory.
• Fade function (p. 3)
• Detailed settings for the Recall Filter function (p. 5)
✔ The following effects have been add to the effect types.
• CE-1 (p. 7)
• DD-3 x2 (p. 8)
• DM-3 x2 (p. 9)
• DIST x2 (p. 10)
• MASTERING (p. 11)
✔ The delay time of each delay for the respective channels and monitors can be set at a maximum
of 1.2 seconds.
✔ New functionality has been added to DCA groups (p. 17).
• DCA groups 9 to 24 added
• CHANNEL DISPLAY screen added for DCA groups
✔ New functionality has been added for monitoring (p. 21).
• Dimmer function
• Prohibition of operation from the LEVEL knobs in the top panel's MONITOR section
✔ Other new functionality
• LO SHELF 2 (LSV2) and HI SHELF 2 (HSV2) have been added to the 4-band EQ types for each channel (p. 23).
• Delay time can be set in sample units (p. 24).
• A function has been added to exclusively switch off sends to MAIN L/R or to MAIN C when sends to MAIN L/R and
MAIN C are on (p. 25).
• Functions that can be assigned to user buttons have been added (p. 25).
• A function has been added that automatically applies the channel names on the M-480 to the track names on the
R-1000 when an R-1000 48-track recorder/player is connected and the M-480 is used as a recording source (p. 26).
• The following RS-232C commands have been added.
For more information, refer to "V-Mixer RS-232C Reference."
◆ Control commands
• Display blackout/cancel blackout
• Display brightness setting
• Panel brightness setting
• Lamp brightness setting
◆ Request command
• REAC connection status request
• Display blackout status request
• Display brightness request
• Panel brightness request
• Lamp brightness request
◆ Reply-use commands
• Error status
• Connection-destination REAC device error status
To Next Page
Loading...
