6
New functionality for scene memory
2. From the scene list, select the target scene, then press [F4 (PARAM EDIT)].
This accesses the RECALL PARAMETER EDIT popup.
The RECALL PARAMETERS selection buttons are displayed as shown below, depending on the state of the detailed
settings for the Recall Filter function.
In the case of , pressing [ENTER] displays the RECALL PARAMETER DETAIL popup.
3. Press [F4 (DETAIL)].
The RECALL PARAMETER DETAIL popup appears.
❖Channel recall range setting button
Specify the channels to include in the recall range. Clearing a check mark excludes the item from scene recall.
4. Press [F8 (CLOSE)] to close the RECALL PARAMETER DETAIL popup.
5. Press [F1 (RECALL FILTER)] to activate.
6. Press [F8 (OK)] to apply the changes and close the popup.
Display Meaning
Recall none.
Recall all.
Recall only some.
To Next Page
Loading...
