35
Effects editing parameters
23: OVERDRIVE
Creates a soft distortion similar to that produced by vacuum tube
amplifiers.
fig.MFX23
24: DISTORTION
Produces a more intense distortion than Overdrive. The parameters
are the same as for “23: OVERDRIVE.”
fig.MFX24
25: GUITAR AMP SIM
(Guitar Amp Simulator)
This is an effect that simulates the sound of a guitar amplifier.
fig.MFX25
Depth
0–127 Depth of modulation
Feedback
#2
-98– +98 % Adjusts the amount of the flanger
sound that’s fed back into the effect.
Negative (-) settings invert the
phase.
Step Rate
#1
0.10–20.00
Hz, note
Rate (period) of pitch change
Phase 0–180 deg Spatial spread of the sound
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Balance D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the flanger sound
(W)
Level 0–127 Output level
Parameter
Value Description
Drive #1
0–127 Amount of distortion
Also changes the volume.
Tone #2 0–127 Sound Quality
Pan L64–63R Stereo location of the OVERDRIVE
output
Amp Sw OFF, ON Amp simulator on/off
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK
Type of guitar amp
SMALL:
small amp
BUILT-IN:
single-unit type amp
2-STACK:
large double-stack amp
3-STACK:
large triple-stack amp
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Level 0–127 Output level
Parameter
Value Description
Amp
Simulator
2-Band
EQ
L in
R in
Over
drive
L out
R out
Pan R
Pan L
L in
R in
L out
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Distortion
Parameter
Value Description
Pre Amp
Sw
OFF, ON Turns the amp switch on/
off.
Pre Amp
Type
JC-120,
Clean Twin,
Match Drive,
BG Lead,
MS1959I,
MS1959II,
MS1959I+II, SLDN
Lead, Metal 5150,
Metal Lead,
OD-1, OD-2 TURBO,
Distortion, Fuzz
Type of guitar amp
Pre Amp
Volume #1
0–127 Volume and amount of dis-
tortion of the amp
Pre Amp
Master #2
0–127 Volume of the entire pre-
amp
Pre Amp
Gain
Low, Mid, High Amount of pre-amp distor-
tion
Pre Amp
Bass
0–127 Tone of the bass/mid/tre-
ble frequency range
* Middle cannot be set if
“Match Drive” is selected
as the Pre Amp Type.
Pre Amp
Middle
Pre Amp
Treble
Pre Amp
Presence
0–127
(MATCH DRIVE:
-127 - 0)
Tone for the ultra-high fre-
quency range
Pre Amp
Bright
OFF, ON Turning this “On” produc-
es a sharper and brighter
sound.
* This parameter applies to
the “JC-120,” “Clean
Twin,” and “BG Lead”
Pre Amp Types.
Speaker Sw OFF, ON Determines whether the
signal passes through the
speaker (ON), or not (OFF).
Speaker
Type
(See the following
table.)
Type of speaker
Mic Setting 1, 2, 3 Adjusts the location of the
mic that’s capturing the
sound of the speaker.
This can be adjusted in
three steps, from 1 to 3,
with the mic becoming
more distant as the value
increases.
Mic Level 0–127 Volume of the microphone
Direct Lev-
el
0–127 Volume of the direct sound
Pan L64–63R Stereo location of the out-
put
Level 0–127 Output level
L in
R in
L out
R out
Pan R
Pan L
Pre Amp
Speaker
MC-808_Slist_e.book 35 ページ ２００７年９月７日 金曜日 午前１１時１１分
To Next Page
Loading...
Need help?
General
