Roland MV-30 - Hearing the RPS Demo Song

@@@
-
5. How to
hear the
tape
sync
demo
song
The
MV-30 has
a built-in Tape
Sync II function,
which
allows
it
to
record
and
playback
in
synchroni-
zation with audio
tape or video
tape. The
disk and
cassette
tape
included
with the MV-30
contain
demo song
for
synchronized
playback.
The left
channel
of the cassette
tape contains
the vocal,
and
the
right
channel
contains the sync
signal.
To connect
the MV-30 with
your
cassette
deck,
you
will
need
a cable
with
phono plug
on both
ends.
O
wtake
connection as
shown
in
the diagram.
€)
Refer
to steps
O-€)
in
"Playback
the
second song"
on the
page1S,
and
load
"confusion"
as
the second song.
@
Press
the l-prTl
key and
press
l>7lT1. The MV-30
witt
standby
for
playback.
x
Since
the
Sync Mode of this has
been set to
r.Tape",
the MV-3O
will
not
actually
start
playback
when
you
press
,rT)
but will for
a tape
sync
signal.
@
lnsert
the included
cassette
into
your
cassette tape deck,
and
playback
side
A.
(Noise
reduction
on
your
tape
deck should be
turned
off.)
The
MV-30 will begin
playing
back in
synchoniztion
with
the
tape.
*
lt is
also
possible
to synchronize from
the middle
of the
song.
x
lf synchronization
problems
occur, increase
the
playback
level
of the tape.
xThe
audio
cassette
included
for
demonstration
purposes
contains only
two
tracks
of
information.
..Grosstalk,,
may occurr
and the
tape
sync signal
may be heard
through left
channel during
playback.
This is
normal
and
should
not cause concern.
@
To
exit
from
the tape sync
stadby condition,
press
a>7]T). The
MV-30
will
exit
play
standby mode.
o
tr
START,/STOP
o
STAFT,/STOP
o
17...