Roland MV-8800 - Page 35

Effect Block
A-35
MV-8800 Appendices
About MIDI
Effect Block
SpecificationsMIDI Implementation
Pitch (Stereo pitch shifter)
This effect changes the pitch of the source sound. The
degrees of pitch shift can be set separately for each channel.
Stereo Link
Value: Off, On
This selects whether the pitch shift in left and right
channels are to be linked or set independently. When set
to “ON,” the right channel pitch shifter settings conform
to those set for the left channel.
Grade
Value: 1, 2, 3, 4, 5
Sets the grade of the effect sound. The higher the value
is set, the more natural-sounding can be obtained;
however, this increases the delay from the source sound
as well. Depending on the setting, you may be able to
hear some disruption of drums and other parts, so select
the suitable setting after listening to the sound at
different settings.
Lch Pitch/Rch Pitch (Left/Right Channel Pitch)
Value: -12–12
These set the degrees of left and right pitch shift. You
can adjust the pitch shift in semitones.
Lch Fine/Rch Fine
(Left/Right Channel Fine Pitch)
Value: -100–100
These set the degrees of left and right pitch shift. You
can adjust the pitch shift in cents (1/100 of a semitone)
for minute adjustment of the pitch shift.
• When Stereo Link is on, changes to the right channel
settings are ignored.
Effect Level
Value: 0–100
Sets the volume of the effect.
Direct Level
Value: 0–100
Sets the volume of the source sound.
• When simply changing the pitch of the source sound, set
the direct level to 0.
13 Stereo Pitch Shifter
MV-8800_a_e.book 35 ページ ２００６年１１月１０日 金曜日 午前１０時１９分