Roland PC-300 - Power supply

6. Connecting & setting up the PC-300
7
Owner’s Manual
The PC-300 can be powered using the
supplied adapter, or via a USB connection
with your computer.
Power supply
Using the USB power supply
1. Connect the PC-300’s USB port to a
free USB port of your PC (see page 10).
This requires the use of the supplied USB
cable.
2. Switch on your computer.
Using the supplied adapter
Note: Be sure to use only the specified AC
adapter (ACA series). Using any other type
may cause malfunction or electric shock.
Note: If the unit is to remain unused for an
extended period of time, unplug the power
cord.
1. Check that the PC-300 is OFF.
2. Connect the AC adapter to the DC IN
jack, and the other end to a power outlet.
Set to "ON (USB)"
To a USB connector of
you computer
ENGLISH