Roland RD-100 - Recording Your Own Music; Erasing the Recorded Data

16
RD-100
Feb, 1999
4 : A/D Check
Press the "Transpose" button and the 7-seg display shows:
Press each of the following pedals. Their corresponding LEDs will turn on as shown below. A value (0~10) will
appear on the 7-seg display and a sine wave sound will be heard. When the value shown is '0', no sound can
be heard; when the value is "10" a bell sound will be heard.
Items for A/D check LED
Damper Pedal ð Demo
Soft Pedal ð Beat
5 : MIDI check
Press the "Transpose" button and the 7-seg display shows:
Hook up MIDI IN and MIDI OUT sockets via a MIDI cable and make sure that the 7-seg display shows:
6 : How to finish or start the test again
Press the "Transpose" button and the 7-seg display shows:
If you press this button again, you'll go back to the beginning of the Test Mode and the display will show:
To exit the Test Mode definitely, turn the instrument off and then on again.
JIG
END
0__
SER
AD