Roland RD-2000 - Page 3

3
Using the V-Piano Expansion
Installing the V-Piano Expansion
Saving Files To a USB Flash Drive
* When using a USB ash drive for the rst time, you must format it
on the RD-2000.
Ø
“Formatting Memory (Format)” (Owner’s Manual)
1. Connect the USB ash drive to your computer.
2. Save the le (M09X01_GrmnCnct.exz) to the root
directory of the USB ash drive.
3. Disconnect the USB ash drive from your computer.
Installing on the RD-2000
1. Insert the USB ash drive you prepared in “Saving
Files To a USB Flash Drive” into the RD-2000’s USB
FOR UPDATE jack.
* The RD-2000 is equipped with multiple USB ports. When installing
the V-Piano Expansion, use the USB FOR UPDATE jack.
2. Turn the power of the RD-2000 on while holding
down the [ENTER] button.
RD-2000 starts at “EXP Update Mode”.
3. Use the cursor buttons to select the slot (SLOT-SA/
SLOT-SB) to add, and then press the [ENTER] button.
File on USB ash drive appears.
* V-Piano Expansion can be installed in either SLOT-SA or SLOT-SB.
4. Select the le to add, and then press the [ENTER]
button.
5. When the message “Are you sure?” appears, press
the [ENTER] button to execute.
* While data is being written, the message “Writing” is displayed. The
data write time is approximately 12 minutes. When the message
“complete.” appears, the operation is nished.
6. Turn the power o, then on again.
This allows you to use the V-Piano Expansion.
Uninstalling a V-Piano Expansion
If there is no free slot, you can uninstall Expansions that are already
installed, and then install the V-Piano Expansion.
1. Hold down the [ENTER] button and turn the RD-2000
on.
RD-2000 starts at “EXP Update Mode”.
2. Use the [
à
] [
á
] buttons to select the le to uninstall.
3. To execute, hold down the [SHIFT] button and press
the [WRITE] button.
Selecting a V-Piano Expansion
1. Press the [EXP] button.
Each time you press the [EXP] button, the model expansion
switches to A/B/SA/SB.
* You can check the installed model expansion in “MENU”
Ó
“System”
Ó
“INFORMATION”.
* V-Piano Expansion can only be selected for ZONE 1.