Need help?Do you have a question about the Roland SRA-1200 and is the answer not in the manual?
Describes front panel controls: Power Switch, Pilot Lamp, Attenuators, Clip Indicators, and Protection Indicators.
Details rear panel components including cord hook, power cord, fuse holder, terminals, input/output jacks, and switches.
Illustrates stereo and BTL setup wiring for SRA amplifiers, including input and speaker connections.
Details monaural and parallel BTL/monaural setup wiring for SRA amplifiers, emphasizing power configurations.
Guides on setting mode switch, level selector, and attenuators for initial amplifier operation and volume control.
Presents the internal block diagram for the SRA-1200 power amplifier, showing signal flow and components.
Illustrates the internal block diagram for the SRA-2400 power amplifier, detailing its circuit architecture.
Shows the internal block diagram for the SRA-4800 power amplifier, outlining its electronic structure and signal paths.
Lists detailed technical specifications for SRA-1200, SRA-2400, SRA-4800 including rated output, THD, and S/N ratio.
Provides physical dimensions, weight, power supply requirements, and input/output connector details for SRA series.
General| Power Output | 600W x 2 (4 ohms), 380W x 2 (8 ohms) |
|---|---|
| Total Harmonic Distortion | 0.05% (1kHz, 8 ohms) |
| Frequency Response | 10Hz to 70kHz (+0dB, -3dB) |
| Input Sensitivity | +4dBm |
| Signal to Noise Ratio | 105dB |
| Input Impedance | 20k ohms (balanced), 10k ohms (unbalanced) |
| Impedance | 4 ohms, 8 ohms |
To Next Page
