Roland super quartet mks-7

IMPORTANT NOTES
Power Supply
@ The appropriate voltage to be used is shown on
the name plate of the rear panel. Be sure that it
meets the line voltage system in your. country.
® Do not use the same socket that is used for any
noise generating device, such as a motor, or
variable lighting system. .
@ When setting up the MKS-7, be sure that all the
units are turned off,
@ This unit might not work properly if turned on
immediately after turned off; or if the power
cable is plugged in with the unit turned on. If
this happens, simply turn the unit off, and turn it
on again after a few seconds.
@ This unit might get hot while operating, but
there is nothing to worry about it.
CONTENTS
[1] PANEL DESCRIPTION. .-...---------- 3
[2] CONNECTIONS..........-.-.-.---- 6
[3] OPERATION............ Seta arate taka 7
1, MIDI Channel Setting .------- +--+ -5-- 7
2. Tone Color Selection (1) ------+--+--+--- 9
3. Tuning . seer ccc eee ee eee eee 12
4. Level Setting adiat nat aa ley l cohiw lia: ihe ined By ae Se oak te: 12
5. Setting Dynamics Sensitivity .-------.--- 13
G. Key Transpose «6 ee ee ee ees 14
7, Pitch Bender and Modulation Sensitivity --- 15
8. Other Useful Information---.----.---+- 16
Cleaning
@ Use a soft cloth and clean only with a mild
detergent.
® Do not use solvent such as paint thinner.
Location
@ Operating the MKS-7 near a neon or fluorescent
lamp may cause noise interference. If so, change =
the angle or position of the MKS-7,
@ Avoid using the MKS-7 in extreme heat or
humidity or where it may be affected by dust.
[4] APPLICATIONS ............-.---. 18
1. MIDI Functions ... --- tenes ae ae 18
2. Whole Mode ..-..- ben Ae ao Get ar east tea Me Gog he ts 19
3. Tone Color Selection (2) ....---.-.-.. 21
4. System Examples eis Dust ome a HR wR ae DEAE Gas Co RNa 22
[5] SPECIFICATIONS ..-.......-..-.-. 24
Please read the separate volume ‘‘MIDI"' before this manual.