Roland INTEGRA-7 SuperNATURAL User Manual

SERVICE NOTES
Issued by RJA
Copyright © 2012 Roland Corporation
All rights reserved. No part of this publication may be reproduced in any form without the written permission
of Roland Corporation.
CC-KWS17058830E0
Sep. 2012 INTEGRA-7
Table of Contents
Cautionary Notes ..............................................................2
Specifications .....................................................................3
Location of Controls (Front) ............................................4
Location of Controls (Front) Parts List...........................4
Location of Controls (Rear)..............................................5
Location of Controls (Rear) Parts List ............................5
Exploded View ..................................................................6
Exploded View Parts List.................................................7
Plane View (1)....................................................................8
Plane View (1) Parts List ..................................................9
Plane View (2)..................................................................10
Plane View (2) Parts List ................................................11
Wiring Diagram/Block Diagram..................................12
Parts List ...........................................................................14
Verifying the Version......................................................16
Data Backup and Restore Operations ..........................16
Performing a Factory Reset............................................16
Updating the System ......................................................16
Test Mode.........................................................................17
Circuit Board (Main Board) ...........................................22
Circuit Diagram (Main Board: 1/5)..............................24
Circuit Diagram (Main Board: 2/5)..............................26
Circuit Diagram (Main Board: 3/5)..............................28
Circuit Diagram (Main Board: 4/5)..............................30
Circuit Diagram (Main Board: 5/5)..............................32
Circuit Board (Sub, Panel, Jack, VR, ENC, Inlet, Front
Jack, SW Board) ...............................................................34
Circuit Board (Sub Board: 1/4) .....................................36
Circuit Board (Sub Board: 2/4) .....................................38
Circuit Board (Sub Board: 3/4) .....................................40
Circuit Board (Sub Board: 4/4) .....................................42
Circuit Board (Panel Board)...........................................44
Circuit Board (Jack Board) .............................................46
Circuit Board (VR Board) ...............................................47
Circuit Board (ENC Board)............................................47
Circuit Board (Inlet Board).............................................47
Circuit Board (Front Jack Board)...................................48
Circuit Board (SW Board) ..............................................48

Roland INTEGRA-7 SuperNATURAL Specifications

General

Number of Parts	16
Polyphony	128 voices
MIDI I/O	In, Out, Thru
Display	256 x 80 dots graphic LCD
Sound Generator	SuperNATURAL
Wave Expansion Slots	4
Waveforms	Over 6000 waveforms
Effects	Reverb, Chorus, MFX
Inputs	1/4-inch phone type
USB	USB
Power Supply	AC 117 V, AC 230 V, AC 240 V

Summary

Cautionary Notes

Specifications

Location of Controls (Front)

Location of Controls (Front) Parts List

Lists part numbers for front panel controls.

Location of Controls (Rear)

Location of Controls (Rear) Parts List

Lists part numbers for rear panel controls.

Exploded View

Plane View (1)

Plane View (2)

Wiring Diagram/Block Diagram

Parts List

Verifying the Version

Data Backup and Restore Operations

Formatting a USB Memory Device

How to format a USB drive for data operations.

Data Backup

Procedure to save user data to a USB device.

Data Restore Operation

Procedure to load user data from a USB device.

Performing a Factory Reset

Updating the System

Test Mode

VERSION CHECK

Verifies the version of the main program.

DEVICE 1

Automatically tests various internal devices.

DEVICE 2

Verifies audio input/output and USB/MIDI operation.

Audio Output Verification

Verifies audio outputs (B, C, D, Digital).

USB and MIDI Verification

Verifies USB and MIDI communication.

Component Verification

Verifies LCD, Encoder, Noise, Shock tests.

System Reset and USB Test

Verifies reset, ERP, and USB computer connection.

Circuit Board (Main Board)

Circuit Diagram (Main Board: 1/5)

Circuit Diagram (Main Board: 2/5)

Circuit Diagram (Main Board: 3/5)

Circuit Diagram (Main Board: 4/5)

Circuit Diagram (Main Board: 5/5)

Circuit Board Diagrams

Circuit Board (Sub Board: 1/4)

Circuit diagram for Sub Board (1/4).

Circuit Board (Sub Board: 2/4)

Circuit diagram for Sub Board (2/4).

Circuit Board (Sub Board: 3/4)

Circuit diagram for Sub Board (3/4).

Circuit Board (Sub Board: 4/4)

Circuit diagram for Sub Board (4/4).

Circuit Board (Panel Board)

Circuit diagram for the Panel Board.

Circuit Board (Jack Board)

Circuit diagram for the Jack Board.

Circuit Board (VR Board)

Circuit diagram for the VR Board.

Circuit Board (ENC Board)

Circuit diagram for the ENC Board.

Circuit Board (Inlet Board)

Circuit diagram for the Inlet Board.

Circuit Board (Front Jack Board)

Circuit diagram for the Front Jack Board.

Circuit Board (SW Board)

Circuit diagram for the SW Board.