Roland TD-7 - Page 101

I To erase Sequence Data
(D Select3:1€-=-fit‘ l:l1l usiogt'lic[DATA]di;tl,t'henpress[ENTEFi]. ll
The screen l't:5|'tufiLl.‘~i it-'itlil:lt"1-E '£I.3i..4 IE~|..1l""!E'?
The selected Sequence l‘;tttern is played St")ll1;tl"_t-’t'lti can hear it one more time.
® l’res.s" [ENTER] again to erztse the Sequence Pztttern.
To leave this mode. press [EXIT].
ll no tlztta exists in the Sequence l’;ittern you lint-'e selected. the llollott-‘ing screen will ;1[)[)L‘;ll'r 3
When no sequence data exists t
t w;_ {_H7WW_Wmmm f l .
CLEHR FTHEZEJ B A
Cleaefill= UH ?
W hen the sequence data is erased, the mezmure ntimher and heat set in the lollowing section will he
the new values. |The l';tct01"_l= delliult setting for it-"lea.~;tz1'e number is and the default for Beat is
»=i".l
I To set Measure Number and Beat
@ Select l'l=:-us mtr"-is m~Eie=-a1‘.- ltsifig the [DATA] dial.‘ E
ECLEQEFTHEEEJ m ~
e
:LEaePTH[sa1 a
. “eh *@”4
ac-c YE
Q5) :\-’lo\-'et|1etitirstarttsing [4] and [P].then set the value with the [DATA] dial.
\’i-‘hen the preprogramnietl measure number or heat value is edited. '?' will appear to the right of the "
value. "
cLEoePTH£?e1a
Measure W 18?
@ l’ress [ENTER]. The screen responds witl1l:lr”E' '=ltZILt :2-l.ll"'IE"§'
ll
=l=
The selected Sequence Pattern is played so that you can hear it one more time.
® Press [ENTER] to enter the value. To cancel the procedure, press [EXIT]. -
If you have shortened the
number of measures or
the beat, the extra data
is erased. li you have
made them longer, all the
previous data will be
retained.
99 Chapter 5 The Phrase Sequencer