Roland TD-7 - Using the Footswitch and Sound-On-Sound; How to Set the Footswitch Mode

3. Using theFootswitch and Soun-on-Sound
The TI)-T-’ is equipped ii-‘I-‘tilt at jack for connection of l'ootswitcltes. This stereo jack ztllows connection ;
oi two tootswitcltcs ti.-‘hen using ;t special czthle tl’(lS-5.1zoptionttlt. ljse BOSS FS~ ‘iti lot'>ts\\'itt.'l1t.*s I
(optional t.
The lot.>tswitcl1 side oi the connection ctthle has two tttottztttrnl plugs. The iootst\'ittth connected to the 1
plug with the wltite line is Fttotstt-'itt‘lt I and the other is F'oots\\=itclt 2.
FOOT SW
Wlten at l)l’~Z l'ootsn'itclt (optional l is cottnectetl to the Ft.)(t[S\\-’llL'll_lLlt.'l§, Ft iotst\'itclt 3 will lt;t\-'e no el'l'ect'.
Footswitch t
White hr? F$.5U
PCS-31
-> i ‘
F-tad ling 3°55
Footswitch 2
[1] How to set the Footswitch Mode
(D Select the Ptttch Play screen, then press [SYSTEM] to select the St-"steztt screen menu.
ts it r-1 ttiitttstt it t
F-"1.-.1 E lII*EI*i Eli Li"I[i*i SE T
1
X K
® Move the cursor to FE-I.-.t. then press [ENTER].
Foot Em = Model
t ll 1 UP 4* EEK‘ 2"”;
® Select one of the three modes using the [DATA] dial.
l"lCu'.':lt'-3 1 Model
This rnotle 1Illt')\\'$ you to cliztnge P-tttcltes ttsittg the
m-q-J
.7“ Mi t'1tswitcltes.
__\__
ll'ltIHfl1'l* Modei
This mode ;tllot\'s you to use the lootsvritc'ltes to sttstsin
sounds and cltztnge Pzttcltes.
I-In an
0» .' I»
...= t...tt't '...= Sooncl-on~sottntl Mode
iv
This mode allows you to use the Sound-on-Sottnrl
ll: nctiz H1.
ls We e 7 '7 _ _ _
Chapter 6 System Setting
124