Roland TD-7 - Page 119

’ c i ’—~~e—:—T—=1 ~ --
I
O Midi In Switch I Midi In (ON/OFF)
""12" "':'? M fiflih 1-ht»--t [j,'5__ *1“?! t--=- :--t t--t "*1
II‘:
- L_ S U”
\‘t'=’hen it is set to OFF. no MIDI ittessttges tire retognized. To control the TD-? VILI it-IIDI. set it to ON.
I Midi Out Switch : Midi Out (ON/OFF)
slot
Widifiuh m an
\\-’hen this pantmeter is set to OFF. no it-IIDI tttL'ss';tgL*.-;tt'L*tl';tt1stttiliL‘LI. To send MIDI mess;tgesI'1'o1n
the 'l'l")-'7’. he sure to set it to ON.
O Midi Mix Switch : Midi Mix (ON/OFF)
stat
Mifiihie *@FF
\‘i-’Iten set to O.\'=. ;t t.'opji' oltlie ittessttges reteit-=etI tlttottgh FVIIDI IN will he sent from MIDI OLT This
is cttlletl St iii Thru. ltlessatges gettenttetl h_t_-' the TI')-T will he mixed witli the ret:ei\'ed messztges and then
sent through MIDI OUT. \l¢'Iten set to OFF. the Soli Tltiu ellect does not Iunetion.
MIDI OUT MIDI {N
I I /CI‘
I O O
Q
U
MIDI QLOCK
Do Po
I Note Ofi Receive Switch : NoteOi1 Rx (ON / OFF)
etet
Heiefiii he *@FF
\‘i-‘lien this p;-trzimeter is set it t OFF. Nttte OII ntessztges are not recognized. When Note Oil ittessages are 1
reeeivetl. the sottntl cttrrenlly heing pI;t§-'etI will he cut oil‘. i\iorm;tII§-'. this pztranteter should he set to
on-1
=i=Bulk Dump data is
transmitted regardless of
the Midi Out Switch
setting.
=::»E::-=: in the LCD represents
the Receiver.
117
Chapter 6 System Setting