Roland TD-7 - Page 133

I Audio Output and Effects
l..e\"el~; Iur three p;tr;tmett.'rs can he set lur the 'l"l'J-"Ts ln.~'lrtuut*nI.~t. W‘ I‘. SH
Output l.e\*e| Sentl l l.e\‘el Send 1 l.e\'e|
'l"he .‘~iounrl Setup tletermines the output mode of Send I and Sentl 2.
The sigrtrtl nl'.‘éentl I tun he seleeletl as either:
@ Input to l§|'let't I I Retterli.’l")el;n-‘I
(Q Output lnrnt lntlivitlurtl Output I
The signztl cl Send 3 can he selectetl us either:
(D Input to Effect" 2 (Chirrtu.-"'I’|;trtgerI
@ Otitput from lIitll\-'it|tI;il Output 2
msrnuustrr 512
'55::::;:g::;;:5i:iri5g;;t5:L::j_~‘ f
FINSTHUMENT 1
I, S o to
M I Fievmb./Delay """" I I ......... ..' Stone
I ; 5 I - I VQLUME Output:
l Output Level O Eff&G!‘l er P5 '
Sound /$1‘ P'"“i"g O or * * " " ”‘**"" ***)©
5 E ChOl'UF/‘Fl-if'iQD§' ‘ lndividaai
ii, Individual
INSTRUMENT Bend? Level :3 °""'“"
I PARAMETER --» svsrsu PATCH
K ttr nae " PAHAMETEH PARAMETER
a air r s re P129 er P.62.64
E
MN —
iiifiiifiiifii
'||| *||| in '1
P P
S SS SSS
6 o
O What is set in Send 1 and Send 2 is common to all the Instruments, that is, if
you select “Output through Individual Output 1”, Effect I cannot be used.
Therefore, it is not possible to “apply reverb to a certain Instrument and output
a different Instrument through Individual Output 1”.
I If you wish to output a specific Instrument through an Individual Output, set
the Send Levels of the other Instruments to zero.
O The level of the Stereo Out for each Instrument can be set with the Output
Level (P. 87) of each Instrument.
OThe Send Level (P. 88) of each Instrument works as an Individual Output
Level, when Individual (I t-ID I I-.1) is selected in the Sound Setup. If, however,
Effect (EFFECT) is selected, it works as an Effect Send Level.
131
Chapter 6 System Setting