Roland TD-7 - Page 139

7 :74’ _ _ _ :._ *"__ _:____ ___ Mike 7 7 _ _ ;_;;:_:7:_'_;:__ *;"'i _;__7 _ __ in-an-an-t _ I-at ' If '77?’ 1’ 77 7 7 7
Pin momoca Pull
No more sequence pattems can be written into memory.
-P lfyou wish to continue to record, erase some unnecessary sequence patterns.
The previous screen will be recalled in several seconds.
Emnta nattorn
You are trying to erase a Sequence Pattern in which no data exists.
--r Select a Sequence Pattern that contains data.
The previous screen will be recalled in several seconds.
Hot cocnesaond
The Trigger Transmit Channel ( fir P. ll5) is not set to the same number as the Instrument Section’s Transmit and Receive channel
(Ii? P.l 15) ,or the Performance Section's Transmit and Receive channel ( KY‘ P.l I6). Therefore, you cannot select an Instrument.
-tr Set the Trigger Transmit Channel to the same number as the Instrument Seetion's Transmit and Receive channel or the Performance
Section's Transmit and Receive channel.
The previous screen will be recalled in several seconds.
Happens low
Pnoss ans new
no . .
O Own IIIO -can I III
The battery that supports the backup system of the internal memory is nearly exhausted.
-+ All data stored in the internal memory may be lost. Have the local Roland Service Center replace the battery as soon as possible.
Ii IQ T».
"' I "3 E -"3
I I
I100 I-n - t-MI? Iii H.“ -|:'-"st" 1--12: IT!
£3‘
The internal data of the TD - 7 is damaged.
--0 Data cannot be restored unless it is initialized. Follow this Initialization procedure:
Q) Press |El\lTER_].
"ea sou suns?
trtnctzea UU_ t---1]: "*:='""1" M
@ Pressing [ENTER] again will recall the Patch Play screen.
* The above initialization procedure will set all the data in the TD - T’ to the factory preset values.
__ ' __ —’ _ ::'_::: f7__i;i%'Tr":_ _ 7 77' _ Jun-1 nu in '" 7'"::r;::"uuQni\c_ " ' "' ' ' innlnnnnlnt tumour _____ "e WW7 *’"* Y"? W '
137