Roland TD-7 - Page 141

Q The volume doesn’t change with different playing dynamics.
Check if the Velocity Sense Curve is set to Fix.
,.
-r lfso, change the Velocity Sense Curve to Normal. (_ 1;‘-it" P.44)
The volume you expect cannot be obtained if the Max Dynamic and Minimum Dynamic are set improperly.
'-+ Change the settings of the Max Dynamic and Minimum Dynamic. (-'»-‘-Ir PI46)
Q When you play the pads quickly in sequence, some pads do not sound.
Check if the Mask Time is set too long.
--t If so, lower the Mask Time value. ( fir P. 47)
Q No sound is produced if you play softly.
Check if the Threshold Level is set too high.
--tr If so, lower the Threshold Level.
Q Effect 1 (or Effect 2) does not work.
Check if the OFF or lNDl\/__l (or lNDlVlD____2) is set in the Sound Setup.
-0 If so, change the settings of the Sound Setup.( 1:1‘ P. I29) '
Phrase Sequencer
Q No sound is produced even by playing back a Sequence Pattern.
Check if you are playing back a blank Sequence Pattern (where no data exists).
-P lf so, select a Sequence Pattern where data is recorded.
Check if you are playing hack a Sequence Pattern where only the Control Change messages are recorded.
-r If so, select a different Sequence Pattern.
Q Indicators flash in the Patch Play screen.
Check if you are playing back a blank Sequence -Pattern (where no data exists). _ -
-0 lfso, stop playback by playing the pad that caused the blank Sequence Pattern to play or by moving to the Pattern Play in the Sequencer
SCFCEII.
Q None of the Pattern Numbers 25 — 48 can be selected in the Sequence Pattern creation mode.
-P Remember that Pattern Numbers 25 — 48 are preset patterns and therefore cannot be recorded. (fr P. 96)
QThe Tempo cannot be edited while a Sequence Pattern is being recorded.
Check ifthe Sync Mode is set to MlDl.
~+ lfso, change it to INTERNAL. (sir P. I05)
Q When you start the Phrase Sequencer via MIDI, a pattern different from what is selected is played.
Check if the same Note Number is assigned to more than one Trigger Signal. When the same number is assigned to more thanone Trigger
Signal, one Sequence Pattern Number is selected in the priority sequence ofTRlG1, RIMI , TRIGZ, RlM2 RlM9 and PEDAL.
--1» lf so, change the Note Numbers. (_ =1? P. 42)
77 ————— __7 _ r**"::_ __ _ __ __ __ _____ mi; _ _ _. __ _ _________ Iv-lI.:;f ___ _ _ nu In-1"" ";___ I-Ilfivnlh-11 ' '
139