Roland TD-7 - Page 76

7——— ~~— _ —— — — 7 r~;_r:_:__ __ _ _ _ _~ _ — ~ ———— —___________ __ :; 7 _ _
Glohttl l’erlorr1r.tnee Pu l‘1ltttt’[t’t‘.'~i int'lttt.le:
O Key Ftange Low Note / High Note : Low Note / Hi Note (35(B 1) - 93(A 6))
PPM Eection e 1
LUM Hfihém 3535 1
] Note Name
Note Number
PFH Section e 1
Hi l-l 1:: he e ti-
Tltis pttrttmeterdetermines the r;tngeol"'i\ioteNumhers that l.‘2.lL'l1 l’erl"‘orn1;mee Section can t'et‘ei\'e. A113‘ l
Note stress;-tge hetween the Key Range Lon-' t the lott-'est note) and the Key Range Hi tthe highest note}
can he rei:eivetl. For t.’X{tt't¥Pltf, il‘)’ott set the r'eceive <:h;tnnels ol the l’eri'orm;tnee Sections to the so me
number and clivicle the sound range ol‘ eztelt sei.'tion with the Key R;rr'tge, yoti can plat-' tlillerertt
] Note Name
Note Number
lttstnirnents in tliilerent sound ranges.
5
r
___ ___, _—_ _ ; — —— — ' '1 __ 1: _ _ __.. ' ___;_1 :*:__ _: 2
. . Wi
<-—~-W----are ------------------- ~~ ~11:-.~ A aaaaaaaaaaaaa -~~—— A P ~
Not Sound Not Sound Sound
Key Range Low Key Flange High
I Control Change Mode : Ctrl Mode (OFF/Decay/Pitch/Nuance)
PFH Eection =1
I“: F" 1 [‘] t"'t fj i-"-it ""' I“! FF
Select the punittieter lI)ec;ty..-’l‘iti:lt.r"i\iu;tnt'e) to be controlled by it-ill)! Control Cliairige itiessuges. The
Control Change Number on that occ:.t:aion is the number set with the "Control Clmnge“ in the Systettt
Parameters. l'_"1PP. 121) If you do not it-'isl1 to control any paranteter. set it to ¥:¥l:l:.
O Level : Level (0 ~ 15)
PFN5ectione1
L~~-1 ~ is
E I-I E w . we
This ptirztmeter sets the volume oleaclt Perlonnttnce Sectiort. Higher \-’1ilL1ti'.Ei will increase the t-iolume.
When set to ll. no sound will he heard.
:1:
=i=
-_:
=i=
lf Key Ftange Low and
Key Flange Hi are set to
the same Note Number,
only that Note Number
will be received. Then it
will be sound.
You cannot set Key
Range Low to a higher
value than Key Flange
Hi, or vice versa.
If you set the MIDI
channel of the Trigger
Section and the Perform»
ance Section to the same
number, you can control
the parameter you have
selected here with the
Hi-hat Control Pedal.
Control Change Mes-
sages can be used only
1 type in TD-7. It is
selected in "System"
(page 121).
Chapter 3 Patch Setting