Roland TR-909 - Page 20

x|f the indicators do not return to the
normal condition as they should. . . .
Rewind the tape and play it back once
again in different playback level.
If you fail again and again, press the Main
Key 1 (Cancel command), and repeat
saving.
* Errors are often caused by wrong ope-
ration, tape drop-out, or contaminated
head of the tape recorder.
Preserving the Data Таре
Please do not keep the data recorded tape
in extreme heat or humidity or near a
strongly magnetic unit such as a speaker
or an amplifier.
C. Load
[Connection]
TR-909
St (OUT олм
00
ТАРЕ MEMORY, | (МС
[Operation]
* Loading procidure is exactly the same as
the verify, except that you should press
the Load Key instead of the Verify Key.
(D Set the tape recorder so that the tape
will be played back from the begin-
ning of the data.
LOAD
ENTER
O e e ө
Vy
Pilot Tone
Tape Recorder
MON. OUT
(LINE OUT)
|
*Set the volume of the tape recorder
the same as set in Verify.
@ While holding the Shift Button down,
press the Load Key then Enter Key.
Indicator Reaction
e о e
ООО О
Modulated the Data
Tone
Waiting ЧЕ Reading |
(à Then swiftly set the tape recorder to
playback mode.
* On pressing the Enter кеу, all the indi-
cators except the Scale Indicator will
go out.
Pilot Tone Modulated Data reading
found Tone found completed
(D |f the Indicators come in just like be-
fore the loading procedure is taken.
data is loaded successfully, so stop the
tape recorder.
LOAD
ENTER