Roland TR-909 - Page 34

35
B. Sync In (DIN) [Operation]
This jack allows the connection of the
TR-909 and an external unit featuring
While holding the Shift Button down,
press the Tempo Mode Button. Then do
DIN Sync Out. Here, the TR-909 serves the same procedure once again. (If the
only as a slave unit.
MIDI
out
MC-4
MC-202 etc
C. TAPE SYNC JACK
The Tape Sync In/Out Jacks on the
back panel allows the TR-909 to play to
the Sync signal recorded on a tape.
MIDI
Tape Sync Signal
[Operation]
a. Recording Sync signal onto a tape.
(Т) Connect the Save/Out Jack on the
back panel of the TR-909 to the Line
In on the tape recorder.
Tape Recorder
LINE/OUT LINE/IN
ТАР ЖЕМОНҮД NE
TR-909 was initially set to INT mode.)
Q When the TR-909 is not running, it @ Turn the tape recorder to recording
emits signal of a certain level. Set the mode, and in a few seconds, start the
recording level of the tape recorcer so TR-909 by pressing the Start Key.
that it reads about —10 to —3VU.
&)When the entire Rhythm Track is
(Ó Turn the TR-909 to the Track Play played up (the TR-909 automanically
mode, then select the Rhythm Track stops running), stop the tape recorder.
to be played.