Roland U-110 - Page 2

TO REDUEE THe Risn OF ELECTRIC
“DONT REMOVE COVERIOR @ACK:.
(NO USER. SERVICEABLE PARTS. INSIDE
#2; REFER SEAVICINGTO,OUALIFEL
In po a
to: lert. thet ser. to the presence ot Inpara gprs g and ae
maintenance (servicing) Jn:
“The” powerSupply. cord of the product should -b
unplugged : :from the outlet when left: unused for
tion with an ..
ers; ‘may be.
0 not operate fora. long: Setod Srna ‘at ae
imi@, level of at level that is Uncomfortable yo
The’ power- ret cord ‘or the “plug ‘has been.
damaged;.or 7”:
+ Objects have fallen, or iiquid’ has been soiled
into'the product; or. ~
The ‘product has-been exposed to rain: or.
): The product ‘does not appear to operate
“normally or exhibits a Wr change in perfor- :
its location o
lon does not interfere with its proper ventilation.
6 The "product should be located. away from heat
‘sources such as radiators, heat registers. 0 or. ‘othe
preci that eee heat. ‘mance: or
he product should be connected oa a | power ‘Sophy
nly: of the type. described in the opératin instruc:
»tions or'as marked’on the product
p The three conductors ‘of the mains
lead attached ‘to. this apparatus. are +
identified with:color.as shown _in.the
ble. below; together with the,
Matching terminal. an the UK type.
ipower piuig,: When connecting: the:
mains lead, tq:-a plug™be~ sure to
weonnect* éach conductorte thes COP sg,
“rect. terminal-as indicated.
"This instruction applies. to the
product for United Kingdom.”:
: Der Deutschen. ‘Burdespost wurde das “inberkefirbringaa dieses Gerat
angezeigt und die Berechytigung zur dices “der Serie auf Ei
AB. Care stiould be. taken so that objects do not fail and
es “Are not. Spilled into the enclosure eoegh
: The product hae been doped the encosure
desctibed ite the: ose the pa instructions::All
“ether servicing should Dayeterted to Gualified s Service
sis = PLUG ;
ae onda [ene Mark On. nthe matehi terminal
Broperty. t
‘ence with radio and taleviaio
found t to éomply with
jong in- Subpart J, of Pa
ep
However, there is no gi
* ‘equipment does cause
n@ their input/output
1 device or ite 1/0 cabi -
0 shieided 1/0 cables. For Roland devicos, you can
Far.non Rolend devices, contact the manufacturer
gone OF mare of the folto
10 antenna Yyntil the interteren:
Y “Move the equipment to one side or the
di0,
iMoreni circuit than the TV or ragio. (That is, ena
A. Set’ are: on .vircuits controtied by different circ
® Plug the equipment into en oi
‘Certain the aquipment and the
we necessary! ou should consult your. deals
additional suggeations. \ You may find helptyl, the following booklet prepered by she Foaeral Com-
munications Commision: “
“How to Identify and Resolve Radio-TV inte
a This booklet is e fromthe US. Government
‘Stock No, 004.000.