Roland V-160HD RCS - Connecting via LAN Cable; Windows Network Configuration

3
Connecting via LAN Cable
This shows you how to use a LAN cable to directly connect your computer to the V-160HD.
V-160HD
1. Using a LAN cable, connect the LAN CONTROL port on the
V-160HD and the computer.
LAN cable
Communication standards
Port CONTROL port (LAN)
Protocol TCP
Port number 8023
2. Power-on the V-160HD.
3. [MENU] button
Ó
“LAN CONTROL”
Ó
set “CONFIGURE”
to “MANUAL,” and press the [VALUE] knob.
The IP address, subnet mask, and default gateway are obtained
automatically.
4. Use the [VALUE] knob to select “INFORMATION,” and
press the [VALUE] knob.
The LAN INFORMATION screen appears.
5. Set a network password (four characters).
Input the password that’s set here when accessing the V-160HD
from V-160HD RCS.
1
Input the password using the [VALUE] knob.
2
Use the [VALUE] knob to select “SAVE,” and then press the
[VALUE] knob.
3
Press the [EXIT] button to return to the previous screen.
6. Use the [VALUE] knob to select “INFORMATION,” and
press the [VALUE] knob.
LAN INFORMATION screen appears.
When “CONNECTED” is shown in “STATUS,” the V-160HD connection
settings are nished.
7. Press the [MENU] button to close the menu.
Computer
Making the network settings on the computer
Windows
1. Working in sequence, click the [ (Start)] button
0
“Settings” (gear icon).
2. Click “Network and Internet.”
3. Click “Change Adapter Options.”
4. Right-click the network connection you’re using, then
click “Properties.”
5. Select “Internet Protocol Version 4 (TCP/IPv4)” and click
the [Properties] button.