Roland V-Mixer VM-3100 - Basic Operation: Listening to Audio; Connecting and Listening to a CD Player; Powering On and Setting Faders

Listening to Sounds
Now let’s connect a CD player to the VM-3100 via analog jacks and
listen to the sound.
Connecting a CD player.
Connect a CD player to Channels 9-10. Analog signals are used for this
connection.
Headphones
INPUT 11-12
DIGITAL IN AorB
DIGITAL OUT A DIGITAL OUT B
AUX SEND
BUS OUT
MASTER QUT
MONITOR
2 Turn the POWER switch on.
Press the POWER switch on the VM-3100’s rear panel to turn on the
power to the unit. The following screen is displayed when the VM-3100
is ready for use.
CH
Pst 234se7.aaminiz L-R
Set the channel faders.
Raise the channel fader for Channel 9-10, to which the CD player is
connected, to the 0 dB position.
"malfunction and/or
a protection circuit. A brief.
interval (afew seconds)
after power up is required ee
‘switched on, but this is
normal, and does-not
indicate a ‘malfunction. ©
USING THE UNIT SAFELY
ivim@isae te NOTES. al:
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong order,
you risk causing.
?
What is the VM:3100 Series
V-Mixing Static
damage to speakers and
other devices::
1.VM-3100.
2.Other instruments
Par Names
oy
This unit is equipped wit
Digital Mixer Workbook
tching on
_ power. Even with the
volume all the way down,
Fataysiolalaersic)