Roland V-Mixer VM-3100 - Adjusting Audio Levels and Tone; Master Fader and Channel Selection; EQ and High-End Adjustment

Bring up the MASTER fader.
Adjust the volume by slowly raising, the MASTER fader to a suitable
level.
tid.
Can you hear the sound?
If the material is not audible, refer to the “What if the sound is not
audible” on p.19 and try again.
Adjusting the Sound
Channel 9-10 and Channel
11-12 cannot be adjusted
with GAIN knobs. If the
sound becomes distorted;
adjust the output level of
the CD player or other
device.
18
After confirming that you can hear the sound output, the next step is to
try adjusting the sound. For now, try adjusting the PAN and equalizer
(EQ).
Select the channel for which the sound is to be adjusted.
Press the [SELECT] button for the channel you want to adjust, lighting
the button. In this case, press the [SELECT] button for Channel 9-10.
3
Hh wedi
od
* E
: —
MinIE —,
La {ta —
= a
ay ite Es
af iE te
- : f Bn
-* _-— i i ™_
ft ae +
md : ipo
Saas ra
| ipo
= y
pa]
Boost the high end.
To adjust the high frequency range, rotate the [HIGH] volume knob.
Before proceeding with an
operation, you can press
the [LEVEL METER]
button to call up the Level
Meter screen...
Ifyou adjust the equalizer
while li tening: ‘to'the
sound, you: may: notice a -
clicking noise. This is nota
malfunction. Tf the noise is :
objectionable, make
adjustments while the _
sound is mot playing.