Roland V-Mixer VM-3100 - Page 19

Rotating the knob to the right (clockwise) increases the volume of the
high end. Set this to a suitable level while listening to the sound.
x a Mide o.s
HFS. Hi BMHs- 6
{"} ee Mid 1.3kHz- O|L Hl
-_ Low 207Hzr @
Next, adjust the PAN.
Press the PAN button to display the following PAN settings.
r
mea ChE Ly Ch OZ gy ch OS ch Oday
a a a
Four channels, including the channel to be adjusted, can be displayed
by pressing the channel fader [SELECT] button.
4
thg718 Chitviz
Ce Link in GO
BiB) W:R6S Bs O WE RES
Rotate the display VALUE volume controls, corresponding to V1-V4
from left to right respectively, to change the L and R values. Set these to
the appropriate positions while monitoring the sound.
4
ChOS/1Ogm gechi112
Link ee in ae
Bid WIRES Br 8 W:RET
With the panning arrangements for Channels 9-12 appearing in the
display, you can use the V1-V4 value knobs to adjust the following
values.
V1.....Channel 9-10 left/right balance
V2.....Channel 9-10 left/right breadth
V3.....Channel 11-12 left/right balance
V4.....Channel 11-12 left/right breadth
SOOOCCEOHEOESEEEDHAAOHAOOHOO SES ESOSSESSESSOSHHOOSHS OS TSO HSOESEHSSSOSOOOOEOOEESOSOSOSEOEEOD
What if the sound is not audible?
Ifno sound can be heard, even when the power is turned on, then check
the following points:
- Does the channel to which the CD player or other device is
connected correspond to the fader you are adjusting?
- Is the CD player or other device playing back?
- Is the fader’s channel muted?
- Are the speakers or headphones properly and firmly connected?
- Has the MASTER fader been brought up?
- Has the CD player's output level been raised?
- Ifheadphones are being used, is the MONITOR LEVEL knob set to
the proper level?
- Is the [AUDIO CH] button lit? Press the [AUDIO CH] button so
that it lights in red.
SOHHSSESHSSHSS LOSSES SS OLSSS SOT SESS SELLE SOSHESSESSVSSSOSSHSSSHOSESSOHOHOSHESSOHSSESOESESSOSEO
se
To change the midrange,
adjust the [MID] volume
knob, and to change the
low end, adjust the [LOW]
volume knob. To adjust the
sound ona different
channel, press:the
[SELECT] button for the
desired channel.
Use the [SELECT] button
to select the desired
channel:
USING THE UNIT SAFELY
IMPORTANT NOTES ‘elc. ”
~-Whatis the VM-3100 Serios
-¥-Mixing Station?
Part Names
he VM-3190
Trying Out!
g
a
os
<
27
s
a
a
x
=
E
=
2
Qo
Appendices
19