Roland V-Mixer VM-3100 - Mixing Digital Sources; Connecting and Mixing Digital Devices

Connecting and Mixing Digital Devices 6,
20
Now try using these basic mixer operations to mix multiple sounds.
Use the following procedure to connect a CD player digitally, and
adjust the instrument and mic signals to achieve a good balance.
Connect the mic and CD player.
Connect the mic to Channel 1 and the CD player to the [IN B] digital
connector.
Speakers
INPUT 11-12
DIGITAL IN AorB
DIGITAL OUT A DIGITAL OUT B
AUX SEND
BUS OUT
MASTER OUT
MONITOR
Adjust the channel faders.
Raise the faders on Channel 1 and Channel 11-12 to the 0 dB position.
Bring up the MASTER fader.
Adjust the volume by slowly raising the MASTER fader to a suitable
level. After adjusting the MASTER fader, temporarily lower the
Channel 11-12 fader.
Better Moang e
The pin assignment for the
XLR type connectors is as
shown below. Before
making any connections,
make sure that this pin
assignment is compatible «.
with that of all your other
devices.
Pe ae gr
SLEEVE axe
Howling could be
produced depending on
the location of microphones
relative to speakers. This
can be remedied by:
1.Changing the orientation
of the microphone(s).
2.Relocating microphone(s) -
ata greater distance from
.. Speakers. fend
'3.Lowering volume levels.
Digital input signals are
automatically input to:
Channel 11-12. If you want _
to change the channel to
which digital signals are
input, please refer to.
Appendices: “Points. for
Sounds from a digital
device cannot be heard
“merely by connecting the
device to the VM-3100. Use
the following procedure to
switch the digital signals.
» Hold down the: {SHIFT] -
button and ‘press the -
" [DIGITAL IN] button.
: 2.Press the [F3] button and:
select."DIN-B.” ..