Roland V-Mixer VM-3100 - Adjusting Levels for Digital Sources

Adjust the mic volume.
Adjust the mic level. First, press the [F1-F4 ON/OFF] button and [F1]
button to show to the pre-fader status. At this point, lower the channel
fader.
Cy
ad
Press the [F1] button to show to the pre-fader status. At this point, lower
the channel fader.
ce
aa)
Adjust the level, rotating the GAIN knob until the meter shows the
proper amount of signal.
Next, press the [F1] button to switch the display to the post-fader
screen. Press the [Fl-F4 ON/OFF] button to eliminate display of the
functions. Raise the channel fader until the meter shows the desired
amount of signal.
Fi-Fa Z
Adjust the CD player’s volume.
After adjusting the mic volume, slowly raise the Channel 11-12 fader.
Adjust the fader until you have obtained a good mix with the mic
88 £ a ab b bo
‘fader down when adjusting —
‘MEM
Keep the Channel 11-12
“USING THE UNIT SAFELY
IMPORTANT NOTES: te:
mics.
What is the VM-9100 Series
V¥-Mixing Station?
Pact Names
MEM
<Ideal Meter Fluctuation>
This is when the meter
normally fluctuates in the
range of 70-80%, without «=.
reaching the maximum. |
MEMD
Use the compressor.to.:
compress the signal when
vocals exhibit wide
Digital Mixer Workbook
ia
ay
o
a
a
<