Roland V-Mixer VM-3100 - Applying Effects to Mic Channels; Preparing Channels and Selecting Effects; Adjusting Effect Levels

Adding Effects to the Mic Channel
22
The VM-3100 allows you to add a variety of effects to the mic signal.
Let’s try adding some reverb to the mic signal.
Prepare the channel.
Press the [SELECT] button for Channel 1, so that it is lit.
Adjust the channel faders,
MASTER fader, and GAIN
controls to the appropriate
levels.
Select an effect.
First, select the effect. Let’s try using the reverb effect. Press the
[EFFECTS 1] button. The EFFECTS display will appear. Next, press
[PATCH SELECT] button several times until the REVERB lamp lights.
RViLrsHall >
SFFECTS1
L_) rev Prev Bre Gro GS
Type Time HD-G Dens.
The: VALUE volume knobs
in the display correspond
to V1-V4 from left to right,
respectively. Rotate these
volume knobs to adjust the
Rotate the [EFFECTS LEVEL] knob to raise the effect output level to
somewhere around the 6-8 level.
‘eves.
Adjust the effect level.
Next, press the [AUX SEND] button. The following reverb settings
screen appears in the display.
< giPUX gm AUx
== ne
a Lat
°8