Roland V-Mixer VM-3100 - Digital Mixer Workbook: Monitoring and Troubleshooting; Troubleshooting Recording Problems; Using Digital Monitors DS-90

POCSHSOTHOH SESH HHSOOSSSDOHOSOSST SSO SS ESESCHSOHESESEHSOO ESOS OTE SE SESEHESCESEOSSOOOHSSEOOE
[cannot record correctly / Wrong sounds are recorded...
* Is the output source of the DIGITAL OUT connector set to
“MIX” (mix bus)?
—® Check with EZ Routing page.
1. Press [EZ ROUTING].
2. Press [F1-F4 ON/OFF], then [F2](OUT).
3. Select “DoutA=” with the cursor button >Q].
4. Set to “MIX” by turning the value dial.
5. Press [LEVEL METER] to go back to the level meter page.
¢ Do the MASTER OUTPUTs output the correct signals to be
recorded?
—B> Check the settings of each channel of the VM-3100 such as the
channel fader.
>
a
=
a
&
Zz
f=)
Wy
=
Food
S
=
Bo
3
IMPORTANT NOTES. ele.
Whatis the VM-3100 Series
V-Mixing Station?
¢ Is the digital equipment set to record the digital input signal?
—W Check the digital input setting of the digital equipment.
Part Names
* Some DAT recorders do not support the sampling rate of 44.1kHz. In
this case, please record using the analog connectors.
SOSOHSOHSOSSOHSESSSOHHSHHHHHHESASSHS HASHES OHHSHSESSSSSSESSHSHOSHSSSSSSSSHSHSSSSSHSSSOSSESOEOD
Use the Digital Monitors DS-90
By using DIGITAL OUT as the master output to the Digital Monitors
DS-90, you can mix and monitor the sound without deterioration.
Trying Out the
1
Connect the equipment according to the picture below.
devices before making any :
Digital Monitor ee ee
DS-90
Connect the
Digital Audio Cable
INPUT 9-10
INPUT 11-12
DIGITAL IN AorB
DIGITAL OUT A
DIGITAL OUT B
AUX SEND
BUS OUT
MASTER OUT
MONITOR
Appendices