Roland V-Mixer VM-3100 - Page 30

Adjust the mic level.
Next, adjust the volume level of the vocal mic. Raise the Channel 1 fader
on the channel to which the mic is connected to 0 dB.
Adjust the level while speaking into the mic, rotating the GAIN knob
until the meter shows the proper amount of signal.
cc —>
Finally, add compression.
Press the [COMP1/2] button. The button will light indicating that
compression has been added to this channel.
ao TS
oOo —p :
n&ooe
VM-3100Pro: Hold down the [SHIFT] button and press the
{EFFECTS1](COMP1) button. The button will flash while the
compressor is on).
OUT
EFFECTS!
id —
Rotate the VALUE knobs V1 to V4 to adjust the compressor. The
following settings can be adjusted with the knobs.
i
icy ere
n €3o0
- VI Knob............. Threshold Level
- V2 Knob............ Attack Time
- V3 Knob............. Release Time