Roland V-Mixer VM-3100 - Page 31

In addition, you can use the cursor >{J buttons to select the desired MEMO
knob function. : :
For instructions for
IMPORTANT NOTES:
V1 Knob... OUT Level
parameters, please refer to
the attatched sheets.
Check the overall balance.
Adjust the keyboard, guitar, and vocal mic levels to achieve the proper
~ What is the VM-3100 Serias
¥-Mixinig Statlon?
balance of the signals. Use the faders to make fine adjustments to the
levels.
Watch the level meter in the display as you make the adjustments.
Then set the overall level with the MASTER fader.
This completes the preparation of the VM-3100 for recording toa
multitrack recorder. The next step is to prepare the recorder.
Part Names
Set AUX SEND jack to “BUS” in EZ Routing
With EZ Routing, assign the bus function to the AUX SEND jack.
First, press [EZ ROUTING], then [F1-F4 ON/OFF] to display the.
functions.
i7C Basic EZR
retina Memo... [ Factory
CI
CJ
7
_
Preset
Trying Out the VM-31
Press the [F2](OUT) button.
(Ez)
- CAVE
Press cursor buttons GJ or ~GJ until “Bus 1/2” appears at the top of
the display.
ee Pus -2-aeee »
Se fo
o =i aE ER
a
a
2
G
<
g
a
a
<
31