Roland V-Mixer VM-3100 - Page 40

When you have finished making these settings, adjust each channel MEMO
fader until a proper balance with the cassette tape is achieved. For it :
or instructions on
Adjust the overall volume with the MASTER fader. changing the meter display,
Finally, save this mix toa SCENE MEMORY. This completes the chorus please refer to p.21
mic settings.
Adjust the vocalist mic.
Switch the level screen to Pre, and adjust the GAIN knob until the meter
indicates the proper level. At this point, the channel fader should be
lowered.
cc —>
Go -
Pre}; 2345678 91m0tl2
Return to the Pst level screen and raise the channel fader, adjusting the
fader until the meter shows the proper amount of signal.
Gp -
Fstliaa4se.a9muie
Adjust the overall volume with the MASTER fader.
Next, add compression. For this application, make the settings as
indicated below.
Adjust the pan and equalizer settings as needed.
When you have finished making your settings, save this mix to a
SCENE MEMORY. This completes the vocalist mic settings.
5 Using the VM-3100 as a PA
Try switching SCENE MEMORIES with the order of the event’s
program.
Storing settings in advance for multiple microphone applications can
make your presentations or concert mixes easy.
POPOSHHSSE HOHE HHOOHEESHHOEOHOSSOSHES SO HSHSSOOTHSTSTESTSESOSSOSOSOSSSCO SSS OSOOOSESEESESEE
Tips
If you connect the stage monitor speakers to AUX SEND jacks,
players on the stage can listen to the tape playback sound.
POOSOMEHHS SOOS OOH OT HSS SSE SHSOSSESET OSHS HT TSCHSSTSHSSSESSESHSSHOSSHHSOSSSSSHSOSOOOHTOO SEES
40