Roland VAD506 - HI-HAT CALIBRATION

34
SYSTEM
HI-HAT
If you are using a hi-hat, adjust the oset on the TD-27.
This is necessary in order to correctly detect open/close operations and pedal movement.
Parameter Value Explanation
Trig Type
Refer to “Trig Type list” (p. 30). Species the model of pad (trigger type) that is connected to each trigger input.
Hi-Hat Type
Type of hi-hat
This is set automatically according to the parameter selected in Trig Type.
Oset *1, *2
-100–+100 (automatically)
Extent of opening Hi-Hat
The bigger the value is, the wider the opening extent is.
Reference
For details on how to adjust the oset, refer to “Reference Manual” (PDF). You can make ne
adjustments to the hi-hat parameters as necessary.
Foot Splash Sens *2
-10–+10 Amount of how easy to make the foot splash
Noise Cancel *1, *2
1–3
Amount of strength to cancel the bow and edge noise when you play foot close.
The bigger the value is, the more dicult to have a noise excluding the foot close.
CC MAX *2, *3
90, 127
Value of control change that is transmitted in stepping the hi-hat pedal down completely.
* There’s no need to change this setting if you’re performed only with the TD-27 and the pads.
*1: This is shown only if Trig Type is set to “VH13” or “VH12.”
*2: Digitally-connected pads do not support hi-hat pedal performance.
*3: This is shown only if Trig Type is set to something other than “VH13” or “VH12”