9
Saving a User Patch
Saving a patch overwrites the data in the selected destination patch.
If the destination patch contains data you want to keep, select a
different patch, or back up its data to a computer via USB before
proceeding. To learn more, see the VG-99 Owner’s Manual.
If you’ve changed any settings in the current patch, you’ll need to save them
to a user patch before selecting another patch or powering off the VG-99. If
you don’t, all your changes will be lost.
To save the VG-99’s current settings in a user patch, use the following
procedure:
Press WRITE.
1
Use the PATCH/VALUE dial to select the desired user 2
patch.
To save the patch to the selected location, press WRITE. To exit 3
without saving, press EXIT.
After Step 1 above, you can press the F1 button to display the PATCH
NAME screen and name the patch before saving it. After you’re done
naming the patch, press EXIT to return to the PATCH WRITE screen, and
then continue on to Step 2. You can use this as an alternate naming
method to that described in “Naming a Patch.”
Copying a Patch
To copy a preset or user patch, simply select it and use the above procedure
to write it to the desired user patch location.
Exchanging Patches
You can swap the locations of two different user patches. Here’s how:
Select one of the user patches you wish to exchange.
1
Press WRITE.2
Use the PAGE buttons to select Page 2 in the display.3
Use the PATCH/VALUE dial to select the patch you wish to swap 4
locations with.
Press WRITE to exchange patch locations. To exit without making the 5
exchange, press EXIT.
Initializing a Patch
Initializing a patch overwrites the data in the selected destination
patch. If the destination patch contains data you want to keep, select
a different patch, or back up its data to a computer via USB before
proceeding. To learn more, see the VG-99 Owner’s Manual.
If you like, you can reset all of a patch’s parameters to their default settings.
This is called “initializing” a patch. This is useful when you want a blank slate
from which to create a custom patch.
Select any user patch, and then press WRITE.
1
Use the PAGE buttons to select Page 3 in the display.2
Use the PATCH/VALUE dial to select the user patch you want to 3
initialize.
To Next Page
Loading...
